Posted by 2underage on February 05, 2016 at 11:46:04 from (64.19.81.242):
I have finally done it. I bought a toy that is too big for me. I bought a big excavator for my pleasure and now I have discovered it is to big for me to get on or off it. I got on by driving my loader tractor close and the stepping into the bucket and then up onto the track of the big brute. I played with it for a while taking out some brush rows and rocks. Now I am done playing but, how do I get down and go home? I have a very weak back so jumping seems out of the question and the tracks are covered in mud so I am not to eager to lay down and roll off. It will do me no good to yell for help, I am too far from home and my wife is working on taxes and likely listening to TV. I decide I will have to jump, bad back and all so I position myself near the edge of the track and brace myself for a big jolt to my lame back. Did I mention that the tracks were muddy, well add slippery to that and envision what happened next. . I was facing the cab of the machine when I bent my knees to leap backwards from the beast but suddenly my feet decided to skid toward the cab and launch me, back first, off the machine onto the muddy ground. No I was not badly hurt, just some mud on my face[literally] and a little rub to my pride. Then I discover that my wife has seen it all as she was coming to check on me. When she shared her displeasure with me that really hurt. Anyone want to buy a really big toy?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
