Dave the soybean cups did not singlate the beans at all. They volumetrically ran the soybeans out. Meaning they just ran so much volume out and did not separate the beans at all. Much the same as a grain drill would do. So you would have random spacing. By metering volume you had a chart that would show you the population based on the seeds per pound of seed. You then had to "tune" the rate if your seeds per pound where different than the rate chart. Also when you changed seed brands or lots that have difference seeds per pound you have to adjust your rate.
Then there is the Kinze radial bean meters and then the JD radial bean meters. They basically are a plastic cone/plate that has notches in the outer edge that will hold a single soybean seed. These turn against a brush that helps to keep a single seed in each notch/slot. These are the best way to plant soybeans of the options you would have. In that the spacing is controlled just like the finger pickup does corn. These meters actually count the seeds per acre.
With the cost of soybean seed these days it does not take long for a set of radial bean meters to soon pay for them selves.
P.S. Dave I have set of six used radial bean meters and also a set of soybean cups too. We can talk about what them in an email.
The first picture is a Kinze radial bean meter plate, then a cut away view of a Kinze meter and then a JD plate..
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
