Posted by Bob on January 24, 2016 at 16:34:47 from (64.255.159.192):
In Reply to: Starter repair posted by hrbburn on January 24, 2016 at 16:17:36:
Since the starter at least partially works "on the bench" it seems odd you "don't get anything" when installed on the tractor.
Any chance of a wiring or grounding problem on the tractor?
What happens if you connect jumper cables to a spare battery (even a 12V vehicle, for testing), than connect them directly to the starter?
If the starter is, in fact, defective, there's no use blindly throwing parts at it. The armature and fields need to be checked for shorts and opens, including a "growler" test of the armature.
At this point, if there's an automotive electrical shop in your area, having them look at it is likely going to be cost-effective, vs. blindly buying parts.
I will even toss out the offer to have a look at it for you, if no local help, but, of course, it will cost a bit to ship.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.