Posted by robert major on January 11, 2016 at 10:33:46 from (216.81.16.93):
In Reply to: Parts from China posted by fritzag on January 11, 2016 at 07:59:00:
Hi if it looks like cheap poor made junk compared to the original don't put it in would be my thought. You might be seeing it again fairly quick,You are probably going to find it don't look any different to original though. Most OEM parts come from somewhere like china Mexico or some other European country. JD genuine bearings come from Slovakia or some place like it in europe, that we get in Canada. Good brand bearings that you would think are made in America, come stamped China or Taiwan. some of the JD bearings are a huge price and you can get a better bearing for half the money in my local bearing house!. Been there done that with $300 of failed JD bearings on a baler roll a customer brought in. They looked just the same as any other $10 bearing cut up all over my shop floor, when they failed due to no grease after 2 weeks. Told the guy to go to the bearing house he was suprised what he saved and the bearings are still in it. He then tells me he had another set in another roll do exactly the same thing as this one with genuine JD bearings but his neighbor changed them for him when he used the baler and it went wrong, i bet thats got $150 of bearings in it to!. Regards Robert
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.