In the event the heater and cord check out fine and theres no shock if the equipment ground is removed, it could be as I described below the Ground out there has achieved a voltage higher then mother earth at the barn. Billy Bob or Bubba may drive ground rods right at the tank and bond the equipment ground to earth which may temporarily cure the shock but that's NOT the proper or safest or NEC method HEY DO IT IF YOU LIKE,,,,,,,, REMOVE THE GROUND ORRRRRRRRRR BOND IT TO EARTH !!!!!!!!!!!!!!!!!!!!!!!! but NoT my advice of record lol
Its also very common for Billy Bob or Bubba to have mixed up and crossed and reverse wired the Hot and Neutral in the panel or cords or plugs or receptacles!!!!!!!!!!!!!!!!!! THAT MAY WELL ALSO BE THE WHOLE PROBLEM IE MIS WIRING !!!!!!!!!!!!!
Incorrect or crossed or reversed wires,,,,,,,,,,,bad heater or cords,,,,,,,,,,,,ground has elevated potential,,,,,,,,,,BUT GFCI ISNT THE ANSWER FOR ALL THAT LOL nor are home remedies
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.