Posted by gab on December 30, 2015 at 17:19:52 from (104.235.109.140):
In Reply to: Hey Bruce from Canada posted by Bobl1958 on December 30, 2015 at 11:59:30:
This barn was built in 1948 I think, had a 3 stall parlor, 3 in a row, nice pit on milk house side, pull rope, door slides open,cow comes in, flick a chain, stall opens, pull chain to close, same to let them out. Originally had a pipeline into milk house to cans but was changed 6 or 8 years later to a bulk tank and carry the milk pails to the tank. Ground feed was blown in above the parlor which dropped down 3 pipes to each stall with a hand crank auger for each cow. I didn't do much milking but did a lot of hosing the place down. All those barns used to get filled with small squares plus another big old barn over the hill was usually filled half way.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
