Posted by Donald Lehman on December 18, 2015 at 13:14:39 from (172.79.138.38):
Oldest son was cleaning up a junk pile a while back and found an angle iron frame with a tractor hitch welded to it. The frame was cast with concrete about 14 inches long, but 12 inches high and about 6 inches wide. Had a 3/4 bolt sticking out the bottom of it. He was wondering what the heck that was. It was a weight that Pop made to put on the drawbar of his Allis WC. He had a blade on the WC and he was always complaining about how light in the back end (back end weren't the words he used) that miserable WC was, thus he made this weight to help out when using the blade. Was rather ingenious of him to add the tractor hitch so he could still hook up to stuff with the weight on.
Just put the chains on the 420 yesterday. Decided to bolt this weight on the drawbar and see if it helps much pushing snow. Supposed to get 12-18 inches tonight and tomorrow. Then rain the next day. Predicted to be in the 50's for Christmas. If we get a foot or less, then I won't have to plow at all, just let it melt.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
