Posted by L.Fure on December 08, 2015 at 07:16:56 from (68.169.253.43):
In Reply to: Funny Shop Mishaps posted by Married2Allis on December 08, 2015 at 05:06:26:
Years ago I was at a neighbors shop to help change out a set of snapping rollers in a JD mounted corn picker. We had to change the shafts while doing this. Probably because the ones on the used set we were putting on were worn out. To do this we had to heat the ends of the snapping roll in a coal fired forge. When it was red hot I carried the roll into the shop and clamped it into a large bench vice, then Bob would grab hold of the shaft with a channel lock pliers and work the shaft out. We got the first roll done with no problems. When we got the second one red hot I took it to the vice and clamped it in and Bob grabbed the shaft like he had done the first roll we did. He just gave the shaft a little wiggle, and POW, there was a big bang like a shotgun going off. When the smoke cleared there was Bob standing in a batters position hanging onto the pliers and shaft. His eyes were as big as pie plates. I guess I had the same look on my face, because he asked me if I was alright. I asked him the same thing. Other than having grease splattered on our faces we weren't hurt, just surprised. What had happened was this second snapping roll had the bolts installed at the top of the roll. These were used when the corn stalks were still a little green and the bolt heads were installed to help grip the stalks. With these in the roll was sealed shut and pressure built up in the roll when we heated it. It released when Bob loosened the shaft a little. The looks on our faces after it went off where priceless.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
