Posted by Steve@Advance on December 08, 2015 at 05:55:33 from (108.245.66.82):
In Reply to: Funny Shop Mishaps posted by Married2Allis on December 08, 2015 at 05:06:26:
When I was just out of high school, went to work at an automotive machine shop/garage.
One day I was grinding valve seats. The motor that drives the seat grinder had a hex drive ball on the end, think it turned 12,000 RPM. I had the seat grinder motor in my hand. The owners son who was a couple years younger than me, came over and started horsing around.
I had just taken the drive motor off the seat grinder and it was coasting down. I turned slightly and gave him an elbow to get him to go away, but he stepped forward about the same time. Somehow the drive motor caught his T shirt right in the front center. It instantly balled that shirt up and ripped if completely off! It left a big red pucker in the middle of his belly, but could have been much worse!!! We both just stood there, wide eyed, mouth open, scared stupid!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
