Posted by Steve@Advance on December 07, 2015 at 08:12:59 from (108.245.66.82):
In Reply to: Hyster forklift posted by pea_grower on December 07, 2015 at 07:43:27:
It could be the valve. Try to see if you can stop it from creeping with the engine off. Slightly move the tilt valve, see if it will stop it. If so, could be the centering springs are broken or weak.
More likely it's an internal cylinder seal. Need to leak test the cylinders. Tilt it back, block the mast, take both the front hoses off and plug the cylinder ports. Then release the mast, letting the cylinders hold it.
If it creeps forward, the seals are leaking. If it holds, remove one plug, see if it creeps. If not, replace that plug, remove the other. If it creeps, that cylinder is leaking.
If both cylinders hold, it's the spool valve.
Unless there is a major external leak, the hoses are not causing it to creep.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
