Posted by showcrop on November 26, 2015 at 05:54:29 from (66.31.196.130):
In Reply to: Hey JD seller posted by notjustair on November 25, 2015 at 07:29:10:
Quoting Removed, click Modern View to see
Hot wrench, I don't see it as that big a deal, but maybe that is because I am familiar with the "rungs" not steps, that the OP is referring to. You see, the old silos that were usually unloaded from the top had a top to bottom opening that was approx. 20 inches wide, which, as the silo was filled was blocked off with "doors" that were square, approx. 20"x20". These doors went in from the inside and were held in by a horizontal bail on the outside that doubled as a step. During filling they were added a few at a time to contain the amount of silage going in for the next several hours. During unloading they were removed more like one at a time as the level of silage came down below them. These "bails" were of course 20 inches apart, In addition to these bail steps, there were the heavy rings that run around the whole silo to hold it together. They were approx twenty inches apart and approx. one inch thick. With the doors in place you could not get even your toe on the rings, so they were NOT AVAILABLE as steps, thus you had only every other step when the silo was NEW.before the silo could be filled someone had to climb up on these rings in order to open the port on top and secure the spout of the blower. It was incidental!!!!! I find it hard to believe that anyone who is familiar and a fair amount of fitness would have a problem climbing up there on these indestructible rungs. Another factor is that these openings and rungs are usually covered by a vertical tube. At age sixty five I wouldn't have a problem climbing one of these, provided that I wasn't expected to do it very quickly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
