Posted by stevepcf on November 12, 2015 at 15:20:01 from (24.56.218.177):
Ok, I can't figure out whats going on with this tractor so I'm turning to the internet.
I have a Farmall 656 Hydro. I've had it maybe 8 years, put around 8-900 hours a year on it. I've put 3 or 4 flex plates in it in that time. It keeps breaking the "spider" arms. My serial # ends in 44091. So the book calls for the "spider" flex plate and not the round one with springs. However on the flex plate there's a sticker that says "flywheel side". If I install it that way, the hub of the flex plate hits the charge pump before the tractor "comes together" where it is split. So I have been installing them backwards, but then the splines on the flex plate don't engage the charge pump shaft all the way.
I don't understand what is going on. My flywheel is stamped 396468 R2 L2, I think it's right. Are there different configurations of charge pumps? Is the flywheel wrong? What else could be going on?
BTW it has a D282 motor. Also the wear on the flywheel bolts is from after the flex plate broke.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
