Posted by showcrop on November 12, 2015 at 03:27:45 from (208.93.198.100):
In Reply to: Steering Wheel posted by Spudm on November 12, 2015 at 02:59:00:
Can you post a pic of it? There are a lot of different methods, depending on how badly it is rusted on. First is penetrating oil and time. This has worked for me so far. Next would be removing the nut and any washer and replacing the nut with one that is thinner, so that you can hit the nut and the force transmits to the shaft and not onto the wheel. Give it a sharp blow but not enough to damage the shaft or housing. If you can have someone pulling up on the wheel while you hit the nut it is more effective. A strap around the wheel supported from above through a come-a-long or a load strap can take the place of a helper. I think that I read this one in a manual. Next would be a puller, which of course would have to be of the three fingered type. Effectiveness of pullers is enhanced by striking the puller's bolt head with a good sharp blow when it is good and tight. If none of the above are successful, you may need to resort to cutting it off with a torch or grinder.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
