Posted by Bret4207 on November 09, 2015 at 16:58:47 from (64.19.90.196):
In Reply to: Smile posted by Donald Lehman on November 09, 2015 at 08:12:10:
Quoting Removed, click Modern View to see
I think you have your rounds mixed up or misidentified. The 9mm most of us think if is the 9mm Parabellum/Luger/x19, whatever you want to call it, the standard Glock, Browning Hi Power, Smith 39 round. It's at a little handgun cartridge loaded just a little hotter than a 38 Special. I don't thin anyone is going to put a $4000.00 scope and 2 oz trigger on a sniper rifle in 9mm. And I darn sure know nobody is shooting milk jugs at a half mile with one. I imagine it was some other cartridge.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
