Posted by Deutz Lover on October 15, 2015 at 12:48:58 from (70.193.166.14):
In Reply to: Yellowjacket posted by Hammer House on October 15, 2015 at 09:14:49:
I was going to say wet the area and walls before using a flare. It is useful only if there is nothing but bare ground on the bottom floor. It is better than a bottle of gasoline. Maybe not much better, but dish detergent mixed with water as a wetting agent would probably be better than water alone.
I did use the flares in grassy areas, but did clear a little round the nest hole and had a hose or bucket of water just in case. The only problem is dropping slag from the burning flare. The smoke can be fearsome, but does not propagate flame.
This is ot:
My grandfather used to occasionally spread pine straw on the floor of the chicken coop and flashed it to kill chicken mites. Yes, he did burn down the coop one time, but it was not a very large one to rebuild. Probably worse than plucking chickens all night after being cold nosed by a hound when you are after a fox in the hen house and accidentally discharging a double barrel shotgun.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.