Posted by Charlie in Denver on October 10, 2015 at 13:03:26 from (174.29.241.20):
OK, I'm sure there is an easy answer, but I feel like an idiot. My 1965 Farmall 706 diesel has what I assume are standard PTOs in the rear: the 6 spline 540 RPM and the 21 spline 1000 RPM. The problem is that the 540 PTO has a female output, but the 1000 RPM has a male output. All my equipment (post hole digger, mowing deck) also have female ends on the connecting shafts. So I can put a converter on the 1000 RPM that makes it a 6 spline male, but I understand that will damage the equipment and the post hole digger doesn't really fit well. I can't find a replacement shaft with a male end to connect to the female 540 PTO. Also, all new PTOs also seem to have female outputs. Am I missing something basic here? I appreciate any input (pun intended). Thanks all.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
