Posted by Janicholson on September 26, 2015 at 19:53:18 from (63.152.206.138):
In Reply to: Re: 400 versatile posted by rldck20 on September 26, 2015 at 17:45:32:
Linkage from the chassis to the blower should be a parallelogram. This will keep the bower level and vertical when in use. The lift arms should (best practice) be slightly up hill toward the blower. This prevents the blower from becoming a pole vault device if it stubs into a fixed object. This needs to be only 3 or so degrees. For example if the chassis lower pivot is located one foot from the ground, and the link bar is 2 feet long, the pivot on the blower end should be about an inch and a quarter higher, or 13.25 inches from the ground. Riding up and over a frozen lump of sod (or?) is way better than stubbing into it. a chain or telescoping lift link is needed between the hydraulics, or the lift frame to allow the blower to follow the ground despite the roughness of terrain. Down pressure is not good. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
