Posted by JD Seller on September 22, 2015 at 20:19:12 from (208.126.198.123):
In Reply to: baler market prices posted by blue924.9 on September 22, 2015 at 11:03:39:
Stay away from the IH balers as parts are getting hard and expensive for them. Also IH knotter works different than the JD and NH one. So your friends at the JD dealership would not be much help on it. All equipment is getting softer in price. I was at a consignment sale earlier this month. There was a pretty good JD 336 that only brought $1500. Two JD 24T balers went for under $1000.
So I would shop hard this winter and look for a JD 336 or 327. In NH The 273 is a good lower capacity baler and the 276 is a great higher capacity one. The older JD 14T and 24T are getting old enough some of the parts are harder to get and the price is sky rocketing. New Holland changed little on their balers until the rotary feed system came out in the 1990s. So NH parts are pretty easy to find.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
