Posted by dhermesc on September 15, 2015 at 05:55:20 from (24.248.193.103):
In Reply to: IH baler knotters posted by rkc9700 on September 14, 2015 at 17:02:02:
Easiest thing to do is call SEVERAL different dealers (and ask your neighbors) if anyone knows of a decent baler man. Most likely he'll be in his 60s. You can fight one of those knotters for years and never get it to work right but the RIGHT baler guy will work on it for about 2-3 hours and it will work like a Sears sewing machine. Once correctly adjusted and timed they will run for years (decades on a small farm) without much more maintenance that sharpening the knives every couple years. You may have 100 - 150 miles of road time with it before you find a guy that really knows what he's doing but once they work they work well.
Don't let dealer give it to some guy who's going to read the manual and adjust it because he's the one available when you brought it in. All you'll be doing is burning through money at $100 an hour with no results.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
