My uncle used a grain board about 3'X3'; he hung a pulley on the inside of the door and used a heavy rope attached to the grain board. Someone handled the board (often me) and he pulled the grain to the auger right at the door with his Jeep. We always filled all our bins before we would take anything to the elevator. Usually the prices went up during the winter, so we gained by doing the little extra work.
My brother bought a grain vac-u-vator that just sucked up the grain and put it into the truck. It wasn't speedy, but it got the job done. He installed an air tube that sat on the floor with a large electric fan outside to blow air through the grain. He would run that 24/7 until the grain dried down enough to store, then move it to a straight storage bin and refill the drying bin with more wet grain if needed.
You might be able to find some old bins the same size in the neighborhood that you can buy, dismantle and add rings to your bins. Brother had a set of bin jacks to do that job with; he gave them to our nephew when he retired. Nephew has added rings to his old bins to increase capacity.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
