Posted by Bryce Frazier on August 30, 2015 at 10:19:43 from (67.142.182.23):
In Reply to: ATV question OT posted by bumblebee on August 30, 2015 at 09:42:25:
These guys are right...
That is about the only reason I kept my Kawasaki! a guy gave me this OLD Bayou 300. 2wd, but it has a TOTALLY cool locker in the rear! It is 2 wheel drive, and will turn on a DIME until you dig out, then, moving or not, pull a little lever up, and it just "clunk" grabs up and goes!!!
We have modded the carb a little, it was a 300 engine, still is I suppose, but it flat out runs!!! Wheel standed on pavement! :P
Anyway, my point is, there were a few companies out there that made split rear end fourwheelers, but, I couldn't tell you who.. We had an OLD honda that was set up like this. Horrid machine, but in hind sight, I sure wish we had kept that rear axle.... :/
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
