The rotor in the mag can be rusty and same with the field coil cleaning up both will sure make more spark. Have you cleaned the impulse end in kero or diesel mite be dry or too gummed up for the dogs to lock good as the impulse should have a good snap when it trips. I use a gear that has the female end that drives the mags. I put it in a batt drill so i can vary the speed then having the mag in a vise with wires going to grounded plug so i can give it a complete cycle befor installing on the motor fast slow and starting even slow enough to make the impulse snap at each position 1-4 have wires and all 4 plugs hooked up grounded to bench that way im sure of complete operation when installed.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
