Posted by Billy NY on August 27, 2015 at 12:32:20 from (104.228.35.235):
In Reply to: Re: Where's the bears? posted by Rollie NE PA on August 26, 2015 at 17:10:15:
They wander in here sometimes, but not very often over the years, same as the occasional moose, NYS DEC had one killed across the road several years back, it was estimated to be 300lbs.
I'd be a bit concerned if one like in your photo was a spectator to me working! He's a good looking healthy one! I had a large coyote sit and watch me years ago, I did not see him right away, did not think much of that then, but now, its likely to get solved with bullet.
Years ago I saw coyote bed down for a nap at the bottom of the hill, I was able to carefully sneak up on it, got right up to it, just stood there awhile, he came around, turned his head back, saw me, could not get his feet underneath him quick enough, ran off tail between his legs, heard him tearing through the cornfield til he got to the woods and into the dry leaves, he sure covered some ground, I'll be it only took him a minute to get off he property.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
