Posted by John in La on August 19, 2015 at 17:03:30 from (96.33.136.54):
In Reply to: Getting gas home posted by Fatjay on August 18, 2015 at 20:18:20:
I have posted this several times on here and still some of these guys are way off on there advise.
So here goes again. For the average Joe;
Diesel fuel; Diesel fuel is not regulated by DOT in containers less than 119 gallons. So as long as you use containers less than 119 gallons you can haul as much as you want. All of these slip in pickup bed tanks are rated for diesel only.
Gasoline; Gasoline is a different story. Gasoline is regulated in any quantity so you need to follow DOT haz-mat rules to haul any gasoline. To allow people to haul gasoline home or at work the DOT has made a exemption for small quantities of different haz-mat materials. They call these rules The Materials of Trade rules. For gasoline it must be in a approved container listed in 173.6(b)(4) and 173.202 of the haz-mat rules. This says the container must be approved plastic or metal; be red; and have the word "gasoline" on the container. The container can not be over 8 gallons in size. And you can not haul over 440 lbs in total at one time including the weight of the containers. That equates to about 50 gallons if you use plastic jugs.
Anything above what I have listed above requires Shipping papers Emergency response information Formal training in the transportation of hazardous materials and many other things.
So this is the rules. It is now up to you if you follow them or not.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.