Posted by Goose on August 15, 2015 at 07:40:16 from (70.198.48.103):
In Reply to: barn lighting posted by craig45 on August 15, 2015 at 04:23:33:
I recently put up lights in a new 30X48X12 pole barn. I put two rows of six four tube T8 fluorescent fixtures, for a total of 12 fixtures.
I'm more than satisfied with the result, and I like plenty of light when I work. I got the fixtures from Home Depot for around $40 each, and each fixture has an outlet on one end and a four foot electrical cord on the other. When I installed them, I just went down the line, hanging a fixture and plugging it into the previous one. I put an individual switch on each row, but I only needed one outlet at the start of each row.
A nephew of ours recently put LED lights in a similar sized shop. He claims he spent $14,000 on the lighting system. Even for LED, I thought that was awful high. Since I spent about $600 total including wiring, etc., even if my system uses a tad more electricity it will take a long time to make up the $13,400 difference.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
