JD Seller- I appreciate your response but I don't understand some of your posits. "I was not too worried about myself with the fishermen as I was armed and they where not. ". How did you know they were not armed?
"When you where in the hospital your could not be sure you would have been on top in any altercation. ".- You are correct, very much the same as you..
"As for this current discussion. The judge might not have been entirely legal in his decision".- Yup, the judge was entirely WRONG in his decision. Judiciary can't 'force' "marriage" onto people.
"but all the two had to do was play along and the fellow can/could have been scott free pretty easily."- Why should they "PLAY" along with an illegal summons?
" If they had not wanted publicity them few would have to have known they got married if they did not consummate the marriage."- I don't even understand that remark!
"So someone wanted some fame. I do not know if it was the girl or boy but someone did or we would have never heard of this. ". - Naw, I don't think the couple wanted the fame...I think the Texas Judge wanted the sensationalism much like the Kardashians.
" I am just saying that even with the judge giving a weird condition of the fellow's parole it really is not much of a hardship unless the couple make it so. "- Why are you now trying to MINIMIZE the judges decision? The judge was/is wrong in ordering a couple to marry.
"They can keep right on dating/living just like they have with little difficulty.".- They should have never encountered this predicament to begin with!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
