Posted by Billy NY on July 31, 2015 at 06:56:35 from (104.228.35.235):
In Reply to: Chain or strap posted by craig45 on July 30, 2015 at 16:27:32:
I can say from experience that a piece of a link, hook or hardware from a snapped chain has enough energy to kill or seriously injure.
I was on a site job where these 2 industrious greenhorns got a vibratory roller stuck in deep mud, they tried to take a short cut from the haul road, which was dry. I was working nearby and a flying piece of link or metal hit and put a nice dent in the upright or column of the rops on the caterpillar D5 I was operating. A noticeable thud, it put a dent in it, that's enough to kill.
You may want to re-think your methods, towing heavy logs and creating high tensile forces on your rigging can be very dangerous for the above reason, or worse if the tractor flips back. We just had a post about a tragic fatality recently here, heavy log with some really dangerous rigging, strap, log tongs etc. It can go very wrong, very quickly, with deadly results. Tractor with ROPS and a seat with a belt is going to drastically reduce the risk of injury, you must buckle up in the seat for it to work though.
You can put a thick blanket over the chain, it will absorb energy, but I would not want to be near anything under that much tension, inspect your rigging closely for defects, and don't exceed its limitations, if you do, it will show you no mercy at all.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
