Posted by K Effective on July 28, 2015 at 17:31:28 from (162.235.236.141):
Growing up, we used the old hay grapple forks from the loose hay days to raise baled hay into the barn mow- eight bales at a lift, if stacked right on the wagon. Needed three guys to move well, one to stick, one to drive the lift tractor and one to dump/stack in the mow.
Somewhere along the line, the trolley system wore out and began to dump the load when it hit the top of the track- very dangerous and time wasting. We filled in with a 40' paddle elevator and a lot of carrying.
I located and bought a used tube and chain elevator system, mated with a tube elevator on wheels from the ground. We hung the elevator from the old grapple track and have been loading the mow much more expediantly ever since. I now load almost all of the hay all by myself- throw 30-50 bales on the elevator, stop, run up and stack it and repeat. (yes, I am a stubborn sumbch).
The question in all of this is my method of aligning the drops from the horizontal run of the elevator- I climb up on the tracks and tie the gate open where I want with twine. It would seem there may be some way to open close the gates from the floor, but I can't seem to get the leverage right with twine. Is it just that simple that I am actually doing it right? No big deal when the mow is filled or half full, but that first climb out over the empty floor is a little unerving for a larda$$ like me...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
