Posted by ericlb on July 28, 2015 at 14:27:41 from (67.142.165.22):
In Reply to: Truck tires posted by Leroy on July 27, 2015 at 19:06:35:
i too would go back to the 215's but more important than that is the selection of tread, while you don't need a monster mudder tread pattern you don't want a close tread pattern either, get something open , and with the outside tread blocks open too, some are closed, leaving a solid band of rubber at the outer edge of the tread pattern, these type will not self clean, [ remember the closed center tractor tires of the 1950's, thats why they quit making them], once it makes a revolution or 2 in the soft mud or snow, you have a drag slick i found some tires at my local western auto that are labeled mud and snow, there not a tractor type tread like the older ones were but they are chunky they dont sing noticeably on the highway either, the truck there on is my farm winch truck and it has to go back in the remote reaches frequently to check stock tanks ect sometimes the roads arnt rough, they dont exist at all, so far these tires have worked great, price wasnt bad either something like 139 each for 235-75-16
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
