Posted by Hobo,NC on July 28, 2015 at 09:56:12 from (75.138.197.162):
In Reply to: Pickup AC Repair posted by dhermesc on July 28, 2015 at 09:05:46:
Copy and paste
During Component Replacement
When replacing other components of the air conditioning system, measured quantities of the specified refrigerant oil should be added to the component to make sure that the total charge in the system is correct before the system is operated.
Clean refrigerant oil should be poured directly into the replacement components as follows:
A/C evaporator core (19860): add 90 ml (3 oz).
A/C condenser core (19712): add 30 ml (1 oz).
Accumulator: drain oil from removed accumulator/drier. Add same amount plug 60 ml (2 oz) of clean refrigerant oil to new accumulator.
If any other component such as an A/C evaporator core orifice (19D990) or a hose is replaced, no additional refrigerant oil is necessary unless a hose bursts with a fully charged system. Then, the addition of refrigerant oil may be necessary with the amount to be determined by the technician. The suction accumulator-drier should also be replaced under these circumstances.
That is a general spec I would add 1 oz to the condenser and 2 oz to the accumulator... If I found the expansion tube dry I may add a extra oz... They also sell o-ring kits I would buy a kit just in case I needed a o-ring not supplied with the parts..
You can make a mess removing the expansion tube sometimes you get lucky and can pull them with needle nose pliers... It takes a special tool to remove them and sometimes that does not work... DON'T BREAK IT OFF :!: If you go after it and it does not pull out EZ just leave it be for now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
