Posted by Jon Hagen on July 27, 2015 at 10:16:22 from (69.26.23.81):
In Reply to: Pickup AC Repair posted by dhermesc on July 27, 2015 at 08:22:17:
It's possible that a corroded spot on the condenser blew out under the pressure of hot refrigerant, yet was air tight with only vacuum on the system.
I would replace the condenser myself, rent / buy a vacuum pump and gauge set to recharge it myself. Would cost less than paying to get the job done and them you have the tools for the next "do it yourself" AC repair job.
You may have lost most of the refrigerant oil through the leak, so I would add atleast 4 oz of the correct oil(Ester ?) through those neat little interdynamics "oil charge" cans sold at most auto parts stores
I have maybe $250-$300 in a used vacuum pump, a cheap gauge set,leak sniffer, can tappers, a vent thermometer and a "how to do AC repairs" book. Have done all my AC work on a fleet of cars, pickups and farm equippment for the last 30 years. Saved myself many thousand dollars and got it done when I needed it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.