Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk

Re: Re: Re: Re: Re: Re: Re: Ferguson 6V coil -TEA20


[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]

Posted by Jim WI on August 31, 1998 at 11:04:11:

In Reply to: Re: Re: Re: Re: Re: Re: Ferguson 6V coil -TEA20 posted by Jay Cunningham on August 27, 1998 at 18:08:09:

6.5v at the coil is higher than I expected. Thinking about this again reminded me that your tractor may not have used a resistor when it was a 6v system. If it didn't, then 6.5v is fine. If it did use a resistor, the 6.5v is a little high and may be what caused your problems.

The 335 ohms on the coil is far higher than it should be -- but the 6.5v that you saw at the resistor seems to indicate that the 335ohm measurement is in error. Want to measure the coil resistance again? If you see 335 ohms again I'd guess that's your problem -- just don't see how the 6.5v fits in. New points sounds like a good idea (make sure to adjust them per the service manual) -- I might be tempted to wait on the coil until you try the points.





Follow Ups:



Post a Followup

:
:

: Re: Re: Re: Re: Re: Re: Re: Re: Ferguson 6V coil -TEA20

:

:

:

:


[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point ... [Read Article]

Latest Ad: John Deere B 1943 [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy