Posted by rankrank1 on July 26, 2015 at 07:01:23 from (166.137.14.109):
In Reply to: whats better posted by Nick167 on July 23, 2015 at 18:46:57:
Generally speaking even a well worn haybine will outcut a plain ole sickle mower. The reel on the haybine helps keep the sickle on a haybine free from plug ups.
Your OP stated "business". The word "business" usually implies making money. If you have enough acres you can certainly make a little money haying or if you can operate as a custom operator you can make a little money. If you plan to piddle around on just a few acres of weedpatch fields then doubtful that you ever make any money. While piddling with hay can be mentally rewarding (and frustrating all at the same time) it rarely is financially rewarding.
Been piddling on 5 to 6.5 acres of hay every year since 2008 and have yet to make the first true dollar of profit and I have peanuts invested in all my equipment. I personally enjoy tinkering, patching my old junk, making old scrap iron operational for minimal investment. If you do not enjoy working for free, tinkering on old junk, and dedicating 3 to 4 days of all your extra time each hay cutting in order to a get the hay in then I would not recommend pursuing the endeavor. When hay is on the ground there is no time to go out to eat with wifey, see movies, attend family functions, watch kids sporting events, etc. Missing family events is bad enough when you are making money, but can be a bad sacrifice when you doing it all for free or losing money on a small hobby operation. Only you can answer if the sacrifices are worth it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
