Posted by John T on July 24, 2015 at 05:51:21 from (216.249.74.3):
In Reply to: charging system posted by ohiojim on July 24, 2015 at 04:17:23:
"how do i check to see if my generator is charging, is it a matter of putting the meter to the battery post,"
Put a voltmeter on the battery tractor not running and read voltage, a 12 volt battery would read around 12.6 volts if the battery is good and its charged up or a 6 volt battery 6.3 volts.
Start the tractor and at fast RPM if the charging system is good battery voltage should rise to at least near 13 maybe near 14 volts subject to RPM and genny and VR condition. If it never rises or if it falls, charging system is bad or belts loose or there's a wiring problem.
If theres an ammeter or if you place one in the circuit that can show if its charging or not.
To Polarize a Class A generator, use a jumper wire to momentarily flash jump from BAT on VR or Cutout Relay over to GEN/ARM terminal on a VR or cutout relay DO THAT BEFORE STARTING.
If you want an easy method to diagnose non charging without any fancy test equipment or throwing parts and money at it, work through my Charging Troubleshooting Procedure linked below. In Para 5 it shows how to full field a genny to by pass any Voltage Regulator or Light Switch Low/High charge system problems to see if the genny itself is okay. It also has the Motor Test for testing a generator.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
