Posted by Billy NY on July 08, 2015 at 08:54:14 from (104.228.35.235):
In Reply to: Dunno posted by Allan In NE on July 08, 2015 at 08:36:09:
Some of the comments on the earlier post said it looked like something went through, vs it seizing up and twisting, either or same darned result.. down time and $. So the back up was the baler you went through one winter, many moons ago you showed us?
The thing about the bearings and heat etc, with all this kind of equipment that is running on larger acreage and long hours, how would one monitor for hot spots, one of those things you point and it tells you temperature ?
I know of one close call with that on a 6620 combine, which I greased regularly, low side of a back field, it almost went up and several thousand later for the in field repair, one lousy bearing that more than one 6620 owner was not aware of under cab, and this farmer had all the books on it and guided me through all the fittings as I greased this machine.
I suppose its best it never got hot given the potential, not so good for the fawn. I had one go through a rotary mower a few years back, in front of its mother, there was a twin at least, did not make me feel much better about it though.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
