Posted by Farmall 656 on July 07, 2015 at 18:40:15 from (174.25.220.138):
In Reply to: moving a cornpicker posted by Nick167 on July 07, 2015 at 16:15:59:
Nick, I moved my 234 by unbolting the front divider from the gathering units and was able to put them onto trailers to move. I am not sure about the width of the the Oliver picker, but one trick I have learned from some old-timers who have moved them is to stick a pipe through the stands that rest on the ground. By using one pipe, the picker doesn't want to flex in or flex out. Make sure your pipe is the largest diameter as compared to the stands and at least 12" longer than the length between them. If I were to do it again, I would use the pipe through the stands and 4x4 between the upper parts of the gathering units with ratchet straps and loaded onto a trailer. If the picker is too wide for your trailer, I would unbolt the front divider, and still run the pipe through the stands, push the gathering units together bind them together with ratchet straps and load them. Good luck and let us know how it went!! Maybe take some pictures!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.