I would say your disk timing is way late if you had to put a 5/16 nut in there and that is what makes the twine knife late also. The amount of washers (or nuts & washers) is going to totally depend on the disk timing. I would set it for the half inch measurement, then run a cycle with just enough material to get at least half a bale and quit feeding, trip the bale length arm and immediately shut off the pto. Now you look at the knot still on the bill hook and see if twine is cut completely. If not you increase the distance by adding washers it will cut earlier. Less, cuts later. Too early, needle twine will pull out of disc before knot is complete, too late and not cut completely, the knot will pull apart coming off the bill hook. A big improvement IH came with was a tapered shaft on the disc , double nutted so it is infinitely adjustable to time the disc. Original you had to move shims on the shaft and that did not work well and only small changes possible. A twine end retainer spring was also a big improvement to keep disc twine held onto a little longer. All these changes can be added to a 46 but most already have that done by now.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
