Posted by rankrank1 on July 02, 2015 at 07:30:13 from (166.137.14.59):
In Reply to: 110 v welder posted by 37Chief on July 01, 2015 at 15:14:28:
Forget that HF or any other cheap wire feeder that is AC only output.
Nothing wrong with an AC output stick welder as there are some stick rods that will work with AC output on stick , but there is not a welding wire made for mig (with gas) or flux core designed to work with AC output. The process by its very nature is a DC only process. Should be illegal for merchants to sell those things but lots of idiots buy them because they think they getting a deal and end up with an expensive door stop.
There are cheap wire feeders out there that do output DC, make sure you get one of those if you intent on a cheapey low cost wire feeder. Additionaly one that can do mig mode (gas) will be so much better for body work. than flux core.
Any mig machine can also run flux core wire. However a flux core only machine can only do flux core.
This post was edited by rankrank1 at 07:31:42 07/02/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
