Posted by John T on June 26, 2015 at 13:34:12 from (216.249.74.3):
In Reply to: Solenoid posted by 550Doug on June 26, 2015 at 11:45:32:
SURE a solenoid can go bad, however, before that Id suspect a weak battery or a bad loose burned or carboned connection or even a faulty or jamming starter or starter drive. Remove, clean and wire brush and re attach each and every battery and cable and ground and starter and starter solenoid terminal, insure the battery is well charged, and try her again. A parts house can perform a load test on the battery for no charge.
Also have the meter direct on the battery and try to start her and see what BATTERY VOLTAGE DOES??? if it drops that low Id say the solenoid is okay and perhaps its a bad battery or a bad or sticking/jamming starter. HOWEVER if youre dropping several volts ACROSS the Solenoid, sure it could be bad. A good set of solenoid contacts shouldn't drop many volts under load, the voltage should drop ACROSS the starter motor.
See what the starter does if you use jumper cables and direct jump 12 volts to it????????? If it works good then but NOT with the solenoid in the circuit (starter itself is okay), it could be the solenoid or a bad loose or burned or carboned cable or connection or ground.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
