Posted by Greg1959 on June 20, 2015 at 20:01:25 from (69.176.46.42):
In Reply to: Help me decide posted by John in La on June 20, 2015 at 16:30:06:
FWIW, I'll put my 1/2 cent in.
Two days ago, I trammed(drove) my 1953 Jubilee w/ Wagner FEL and Sherman backhoe, 15 miles to dig a trench. I never shut her down. Even when I took a break, I just idled her down and let her run. Then I trammed her back home 15 miles.
While at the job site, they asked me why I didn't shut her down... I thought my answer was reasonable....'I had just replaced the Radiator, fan belt, cleaned and flushed the gas tank, replaced sediment bowl, flushed engine coolant and soaked in vinegar then rinsed and installed new VDO Temperature gauge'.
I ran her pretty hard for 6 to 7 hours @1500rpm. I wanted to see how the replacement parts performed. Temps stayed in the 160-165 degree range and I was happy.
Now I just got to put the tin back on.
This post was edited by Greg1959 at 20:08:10 06/20/15.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
