Posted by andy r on June 18, 2015 at 21:12:12 from (75.91.149.15):
I have a 1980 GMC straight truck with a GM 366 gas motor. Hits on every cylinder and will sit there and idle nicely. Has the typical dual exhaust with a muffler on each pipe. I did install new donut gaskets between the manifold and the exhaust pipe in 2013. The problem is it seems like you can hear exhaust, especially when the hood is open. Are the manifold to head exhaust gaskets blown out?????? I have owned a 283, 305's, a 327, and a few 350's but never had this problem. But, I seem to think when the head to manifold gasket is blown it will make sort of an exhaust ticking sound?????? Sounds sort of loud. Engine did have the air pump with the pipes into the manifold for pollution control. Has been taken off and the pipes were cut off at the exhaust manifold. I can't feel any air coming out of them. Maybe the exhaust manifolds are cracked??? Any ideas will help. Thanks.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
