I do about the same thing that you do with mowers - salvage older "worn out" ones. Neighbor put a mower out at the curb one day. I asked him why. He said that it had a bad wheel. I took it, put a wheel on it, and used it for about 10 years. Still sets out in the shed but got to be a bit hard starting. Got another one from neighbor on the other side. Said that the engine would not start. He put it out at the curb and bought a new mower. I asked him for the one at the curb and he said that was OK with him. Found out that the safety cable had stretched. So, I took off the blower housing and bent the bracket to accommodate the stretched cable. Ran that for several years, finally sold it to a friend that needed a mower. Still running. Got another MTD mower at an auction for $1. Had it setting out next to the shed for a couple of years waiting for me to "get to it." Drained the tank, put in fresh gas, and it started on the second pull, and has been running for 2 seasons now. I would not be afraid of any old used mower. Most times they just need a minor repair and are good to go for years to come. It does not have to be a top of the line engine on a high end brand name deck to be a good mower. Keep in mind that mower repair shops have 3 month backlogs and charge $100 per hour. That pretty much puts repairs of all but the top end equipment out of the reach of the average person. After all, would you spend $150 plus parts on a $250 mower - and wait 3 months for it to boot????? NOT ME!!!!!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
