Posted by Geo-TH,In on June 12, 2015 at 11:23:19 from (172.78.127.63):
Some people on YT seem to think that rear ballast is the answer to keeping the rear wheels on the ground when lifting with front bucket. That will work, but it does nothing to remove the weight off the front axle. I made 6 concrete weights, 75# each. My little guy's front bucket is rated a little over 1700#, a ¼ yard bucket. It can lift that and more. I can lift enough to pull the rear wheels off the ground.
The hoe weighs only 3100# and lets say I can lift 1900# and it lifts the rear wheels. Physics says all the weight of the tractor plus the 1900# is supported by the 2 front wheels, 5000# total. Adding ballast to the rear tires does nothing to remove the 5000# off the front axle. Yes, rear ballast will keep the rear tires on the ground, but no weight transfer.
My 450# bar bell weights will transfer the tractor's weight off the front tires and move all of it to the rear tires. I'm sure some will argue this fact, but pic says it all. By extending it more, it will also transfer some of the front bucket weight too. I just have to remember to pull the bar bells in before I dump the front bucket or I get a free ride. It's was a little scary at first, but the ride is over as soon as the back hook hits the ground.
Sometimes when I working away form the bar bells, I'll grab a log or something to add ballast.
Neighbor had me make him a 55 gallon drum full of concrete and attach it to a 3 pt hitch so he can lift round bails of hay for his cows.
Physics lesson is over for the day. Try it before you knock it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
