Yo JD, with all due respect, here's a re post of what I said above, but it fits well here also: Its a free country and people are permitted to make their own choices regarding life safety of themselves or children and grandchildren, but FWIW (NOTHING same as any post here) here are my thoughts.
In many many years of practicing under the NEC plus attendance at several NEC seminars, I learned many changes and updates were the result of a fire or death and their whole purpose is to prevent such tragedies. I have met several on the NEC boards, they are NOT bad people, they are NOT your enemy, they are not out to hurt you but instead save your life, they do NOT make law, only render expert guidelines. I also don't consider that as any "silly" cause. Im NOT commenting on how far is too far or excess bureaucratic over reach and regulations, Im ONLY saying as one who used and studied the NEC over a 40 + year career and profession it indeed saves lives if followed. NOTE the NEC has NO legal authority, its only if a town or state etc adopts and approves it that it becomes authority.
Keep safe yall, how you choose to make electrical installations is your decision and your risk as far as Im concerned, do as you please. Being trained and experienced with the NEC and electrical safety and a professional in the field, however, I would choose what the NEC suggests versus some lay untrained electrically challenged Billy Bob or Bubba type of individual or their know it all non electrician brother in law lol.
John T Retired AC power distribution electrical engineer
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
