I figured you'd know if anybody and be in similar (somewhat) growing conditions. Read up on Ergot so I know what to look for. I had 2 fields of Annual Rye. One is a loss due to maturity and seeds already falling off by just the action of the weather. Will work it into the soil and will get some good benefit from it anyway. My Houston Black Clay can surely use a dose of humus.
The other one is a little mature, but still green, seed pods still clinging, about 50-50 Coastal Bermuda. Should make some nice hay for the guy that bought it. He originally wanted both fields, but I'm not going to attempt to sell him the mature one, even though hay will be scarce here this year due to the rain and the subsequent late planting of the summer hay crop.
I cut it a couple of days ago, have been waiting for the sun to come out......finally after the 20" of rain in May (set an all time record). So far the weatherman has done his job. Had a couple of 85 degree days, no clouds, low humidity, and the field is drying out fast now that the sun can see the dirt. Good stubble height, about 4-5 inches so it's off the ground. Machine and tractor are setup for 6' and my drum mower puts out a windrow that fits just inside the tire width so it works out perfectly....don't stomp on the previously cut round.
Way it looks I may leave it be, no teddering, and just before baling, combine 2 rows to give me some working room, don't need it for volume.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
