Posted by middlemiss on May 30, 2015 at 13:21:13 from (50.115.190.39):
In Reply to: Ford 600 tractor posted by Ultradog MN on May 30, 2015 at 12:53:48:
Ultradog MN said: (quoted from post at 12:53:48 05/30/15) Pretty much nothing from an N Series will fit that tractor.
But most everything from 1955 through 1964 will 600,800, 601, 801, etc.
There were a few changes over the years so If you buy it and get into repairing it you could ask on the Ford board here for more specific info.
And not to poke my nose too much into your business but if you give us a hint on the asking price we could at least give you a yeah or nay on whether it's worth it - either congratulate you on a good find or tell you how foolish you'd be to buy it.
Ultradog - thanks for the reply and info. I can grab it for about 850 however its about 3 hours away from me. I think its worth it, but i just wanted to reinforce my decision to sell it to my lovely wife. Seems like the ideal tractor for my small farm.
I will check out the Ford Board.
Cheers.
This post was edited by middlemiss at 13:23:21 05/30/15 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
