Posted by jeffcat on April 27, 2015 at 21:25:43 from (73.197.157.130):
Well I got her running! There is nothing like fixing a carb. with three years of crud and gas leftovers in it! Made a little gas tank that I screwed in to the carb for now. Any who...I am a pretty big guy and a CUB is just a bit on the petite side. My 1977 has the delux two piece seat, Just a little smaller than what would be on a 330U tractor. The two standing brackets are dead center of the seat frame. Would it be advised to drill another set of holes and move the seat back about 2 inches or maybe just a little less? I do not have my knees up under my chin but it aint to far from it. I also think it would be a good idea to buy one of those "steps" that the guy sells on fleabay. Bolt to the right rear housing where the reverse drawbar goes. Looks nice and I don't want to go mountain climbing every time We go for a ride! I just LOVE the sound of these little tractors!!!! They sound like a little gas powered sewing machine. Purr-purr-purr!!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.