DeltaRed said: (quoted from post at 20:56:55 04/27/15) Get the valve from a 1466.It will be 2500. A 706 is only about 1450.The higher pressures PROBABLY wont hurt a thing.But go with a lesser pressure relief (IMHO).Something like a 856;966....Something about 2000 .Any of the 06;56;66 series tractors will work.Keep trying,Joe should get back to you. He's a busy guy.He KNOWS his IH stuff.
Original pressure in a 706 was 1600 psi with an update to a 1800 psi valve. The 2500 psi showed up after the first 86 series tractors came out.
System pressure for 786, 886, 986, and Hydro 186: 2000 - 2350 psi.
System pressure for 1086, 1486, and 1586: 2250 - 2600 psi.
The smaller tractors came with either a 2000 psi valve or a 2300 psi valve. The larger tractors came with either a 2300 psi valve or a 2500 psi valve.
This post was edited by Owen Aaland at 19:32:17 04/27/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
