If you'll be going off pavement, go with a rough terrain model. They will work on both surfaces The low profile, solid tire models will not go off pavement. Even uneven surfaces, like tapered thresholds, ramps etc, give them fits!
Size the lift to the size of your shop. A 2500-3000lb model is much more maneuverable than a 5000lb. Unless you really need the extra lift capacity, go small for a small shop. The small lifts are harder to find. People tend to hang on to them longer.
My preference would be a propane model, gas 2nd, electric 3rd, diesel last unless you can leave the door open or use it mostly outdoors. But the real determining factor would be what I can find, afford, and what condition it is in.
Things to look for, just like any other piece of equipment... Outward appearance means little. Be equally weary of "steam clean and spray paint" rebuilds! Oil leaks are the typical indicator of condition, weather they be hydraulics or drive train, if it's leaving an oil trail, it will soon need repair. But then, sounds like you will be only using it occasionally, and likely you will be the only operator, so no need spending $7000 when $1500 will do you well for many years.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
