Posted by Dodgeit on April 22, 2015 at 09:35:57 from (65.199.61.227):
In Reply to: 903 Cummins reman posted by bradk on April 22, 2015 at 06:23:42:
Quoting Removed, click Modern View to see
The 903 was the worst engine Cummins ever built. They never held up well after a rebuild. You were lucky getting 15,000 hrs. You will be lucky to get 5k after a rebuild. The weakness was always the level of cleaning and tolerance checking the re-builders went through. The level of competence and time needed is huge, which equates to $$$$. A good engine builder can take two inlines apart and put back together in the time it takes to do a 903 and get it to live. Blown head gaskets mostly due to sleeve dimension inconsistences on the mating flange or the mating surface for the sleeve on the block is not pristine, because of dirt or dings. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
